Wednesday, December 4, 2019

QRP Labs Ultimate 3S Case

QRP Labs Ultimate 3S Case

I have taken an old USB cable to modify for 5 volts power. I cut off the end and then soldered the power connector that came with the case kit.
I used a scrap piece of RG58 from the Rf connector at the back of the case to the logic board and wired the power switch and the buttons on the front of the case.

 In the end, I have plenty of room in the case for the GPS board and for the board that will hold five more Low Pass Filters.
 The front of the case gives it a nice finished look.

at
Labels: , , , , ,

1 comment:

  1. AnonymousApril 11, 2022 at 4:49 PM

    Best Casinos with Slots and Casino Games in the US - Wooricasinos
    With online slots, you can play casino games in the USA without risking any deccasino real jancasino money. There are online งานออนไลน์ casinos wooricasinos.info that let you play slots and

    ReplyDelete

Subscribe to: Post Comments (Atom)

Ubitx Broadcast Interference

Broadcast Interference and the uBIT-X When I first wired up my uBIT-X version 5 I found that I had interference from a local AM radio st...

  • QRP Labs Low Pass Filter
    QRP Labs Low Pass Filter  This kit has limited parts and goes very fast. I installed the capacitors first. You may notice extra outlin...
  • APRS Problems
    I have had two problems with APRS this week one is after updating my Pi-Star to the newest software it would no longer talk to BrandMeister....
  • QRP Labs Ultimate 3S WSPR
    The QRP Labs Ultimate 3S is a kit I purchased to build a WSPR transmitter. It is through-hole so it is pretty easy to assemble.   I ...